Bang & Olufsen BeoVision 8-40 User Guide (pre Aug 2010) - Manual (Page 46)

46
Set up the television
For information about how to fasten
and run the cables on the rear of the
television, refer to this page.
For further information about the
connection panels, refer to page 50.
Avoid placing the television in direct sun light
or direct artificial light, such as a spotlight, as
this may reduce the sensitivity of the remote
control receiver. Also if the screen is over-
heated, black spots may appear in the picture.
These spots disappear again, once the tele-
vision cools down to normal temperature.
To avoid injury, use Bang & Olufsen approved
stands or wall brackets only.
Make sure that the television is set up, placed
and connected in accordance with these
instructions.
The television is developed for indoor use in
dry, domestic environments only. Use within
a temperature range of 10–40°C (50–105°F).
Do not place any items on top of the tele-
vision.
Do not attempt to open the television. Leave
such operations to qualified service personnel.
The television was designed to be left in standby
mode when not in use. Therefore, to facilitate
remote control operation, it is essential that
you do not disconnect it from the mains. The
tele vision can only be switched off completely,
if you disconnect it from the mains.
Place the television on a firm and stable surface.
The standard placement allows you to tilt the tele-
vision, for example to facilitate viewing at a low
placement. To tilt the television pull at the bottom
of the television
If you are going to place the television on either the
floor stand or the wall bracket, the two standard
‘feet’ must be removed from the tele vision. Follow
the instructions in the Guide enclosed with these
optional accessories.
Handling your television