Bang & Olufsen BeoVision 8-40 User Guide (pre Aug 2010) - Manual (Page 47)

47
To remove the two covers for the main connection
panel, first pull out, then pull down at the bottom
– also if the television is placed on a stand. To
release the cover for the Smart Card and CA-
module (3), press the cover to the right.
Always remove cover 1 before removing cover 2.
When you have made all the connections and
fastened the cables, mount the cable covers again.
IMPORTANT! For safety reasons the mains supply
cable must be fastened to the cable strip (A). All
cables must be run through the cable strip (B).
However, if your setup includes a VGA connection,
do not run the VGA cable through the cable strip
(B). Instead, use the two screws in the VGA plug
to fasten it to the socket.
If you are going to connect any other equipment
to the television, do not connect it to the mains
yet!
The supplied mains cord and plug are specially
designed for the television. If you change the plug
or in any way damage the mains cord, it will affect
the TV picture adversely!
When connections are complete and the
cables have been secured as described, switch
on the mains supply. A tiny, red light appears.
The system is in standby mode and ready to
be used.
If your television is set up on its own, you can
now tune in channels as explained in the
chapter ‘First-time setup of your television’
on page 26.
1 2
3
A
B