Magnum Energy Magnum Panel (MP Series) User Manual
Page 109
Page 102
© 2011 Magnum Energy, Inc.
Appendix A - Optional Equipment and Accessories
A4
Router Bracket Info
14.45
.
13.60
.
1.0
.
1.0
.
3.0
.
0.65
.
0.5
.
1.0
.
0.85
.
0.3
.
0.28
.
0.28
.
3.0
.
8.0
.
1.0
90°
90°
A3
Inverter Hood Info
The inverter hood is a powder-coated steel cover plate, designed to prevent inverter damage from
objects falling through the top vents of the inverter. The hood is required for installations when
the inverters are mounted on a vertical surface (DC side down) - such as on the MP enclosure.
Info: The hood does not mount to the inverter chassis, it must be mounted against the
wall. The mounting slots on the hood will accept up to a maximum 1/4 inch screw/bolt.
CAUTION: The hood is not to be used as a drip shield to prevent water drip from
entering the inverter.
Installation Guidelines:
1. The bottom edge of the hood must be mounted fl ush against the top of the Magnum inverter;
this is the optimal position for minimizing the risk of objects falling into the inverter, and at the
same time providing the clearance needed for air fl ow from the top vents of the inverter.
2. Do not place anything on top of the hood that might cause it to bend downward; or, place anything
on the sides to restrict air fl ow through the inverter.
.
10
7 ¾
.
1½
Figure A4-1, Router Bracket Dimensions
Side View
Front View
Figure A3-1, Inverter Hood Dimensions
1. Dimensions are in inches.
2. Material = 16 gauge steel.
3. Finish = Powder coat white.
4. Weight: 2.6 lbs. (1.18 kg).
Mounting
Slot Detail
1. Dimensions are in inches.
2. Material = 16 gauge steel.
3. Finish = Powder coat white.
4. Weight: 1.5 lbs. (0.7 kg).