Magnum Energy Magnum Panel (MP Series) - Manual (Page 24)

© 2011 Magnum Energy, Inc. Page 17
3.0 Installation
3.0 Installation
This section describes the requirements and recommendations for installing the MP enclosure.
Info: This installation section primarily explains the installation of one inverter on the
MPSL/MPSH enclosure, and two inverters on the MPDH enclosure. When additional
inverters are required, the optional MPX enclosures are used. Refer to the MPX Extension
Owner’s Manual (PN:64-1015) for information on installing these additional inverters.
3.1 Pre-Installation
Before proceeding with the installation:
• Please read and familiarize yourself with the entire Installation section.
• Read and ensure you understand the “Important Product Safety Information” and the “Important
Battery Safety Instructions” at the beginning of this manual.
• Be aware of all safety and electrical codes which must be met.
• Inspect all shipping cartons for evidence of physical damage. If a shipping carton is damaged,
request that the shipping agent be present for inspection when the carton is opened.
• Unpack the MP enclosure box and remove the components. Verify that you have the components
and hardware as listed below in Section 3.1.1 (and shown in Figures 3-1 and 3-2).
• Use the information in Section 3.1.2 to help identify most of the materials and tools required
for the installation.
• Read the information provided in Section 3.1.3 to properly plan for the installation.
3.1.1 MP Parts Included
Refer to Figures 3-1 or 3-2 (and the item list below) for you particular MP model to verify the
necessary parts are included. If items are missing, contact your authorized Magnum Energy dealer
or Magnum Energy.
Info: Save your proof-of-purchase as a record of your ownership; it will be needed if
the unit should require in-warranty service.
1a
MPSL or MPSH Models - The MPSL-30D, MPSL-60S, and MPDH-30D use a single enclosure
to provide the AC/DC breakers, busbars, and wiring for the inverter’s AC and DC circuits.
1b
MPDH Model - The MPDH-30D uses two enclosures, one enclosure (AC Side) provides
the AC breakers, busbars, and wiring for the inverters AC circuits; and, the other
enclosure (DC Side) provides the DC breakers, busbars, and wiring for the inverter’s
DC circuits.
2
Inverter Hood - The inverter hood is required to be installed over a Magnum inverter
that is mounted on a Magnum Panel to prevent items from falling into the ventilation
openings at the top of the inverter. See Section A3 for more information on this hood.
3
Knockout Plate - The knockout plate is provided as an upper conduit plate, or as a
safety plate. See Section A5 for more information on this plate.
4
ME-RTR (Router) Bracket Kit - This kit consists of the router bracket and the hardware
to attach the ME-RTR (i.e., Router) to the side of the MP enclosure. This kit is not
provided with the MPSL-60S model. See Section A4 for more information on this kit.
5
MP Hardware Kit - This hardware kit consists of the Charge Controller bracket and
hardware (see Section A1), the owner’s manual, communications cables (see Section
3.8), and a front cover label set (see Section 3.15).
6
MP AC Wiring Kit - This wiring kit provides the appropriate AC wires needed to connect
the inverter’s AC input and output terminals to the MP enclosure. See Section 3.6.3 for
more information on this kit.