Emerson Process Management 3000 - Manual (Page 7)

HIGHLIGHTS OF CHANGES
APPENDIX D
Effective June, 1994 Rev. 2
Page Summary
Page D-1
Page D-2
Page D-3
Page D-4
Page D-7
Page D-8
Page D-10
Page D-11
MPS outline drawing changed to show new MPS.
MPS interior view replaced with new MPS in Figure D-2.
"Optional" for check valve deleted in Figure D-3.
Drawing showing location of optional Z-Purge added as Figure D-4.
Power supply replacement procedures in paragraph D-7 changed to
reflect new design in the MPS. Solenoid valve replacement proce-
dures in paragraph D-8 changed to reflect new design in the MPS.
Old exploded view of MPS replaced with new MPS.
Paragraph D-11, Adding Probes to the new MPS, added.
Change part numbers for the power supply, solenoid valve, and test
gas flowmeter assembly. Add part numbers for reference gas flow-
meter assembly and all the parts in the probe adder kit.
Effective January, 1995 Rev. 2.1
Page Summary
Page D-1 Updated Figure D-1, MPS 3000 to include hinge.
Effective May, 1996 Rev. 2.2
Page Summary
Page D-11 Updated replacement parts list to reflect new part numbers.
Effective January, 1997 Rev. 2.3
Page Summary
Page D-1
Page D-2
Page D-5
Page D-7
Page D-11
Added warning to read new safety instructions.
Corrected Table D-1 Specifications listing, 1
st entry.
Added protective covers and grounds warning.
Added protective covers and grounds warning, corrected item num-
ber errors in paragraph D-6.
Added expanded fuse descriptions.
Effective July, 1998 Rev. 2.4
Page Summary
--- Changed test gas to calibration gas and reference gas to reference
air throughout the appendix.