EFJohnson 3000 SERIES - Manual (Page 202)

CALL SEQUENCES
B-2
•
Mobile-2 receives voice communication from
both the DC and Mobile-1.
3. Release the PTT of Mobile-1.
•
The associated CIM changes to Transmit Task
“3”.
•
Both mobiles now receive the DIM voice
communication.
If the associated DIM has Hang Time defined, the
associated CIM enters Hang Task “7” for the
defined time.
When the Hang Time has expired the associated
CIM returns to Idle Task “2”.
• The mobiles return to idle and are silent.
B.4 MOBILE TO UNIQUE ID
Use two mobiles defined to different Home and
Group ID.
NOTE: Some of these tasks change rapidly.
1. Mobile-1, the originating mobile, selects the Auxil-
iary Call group code.
2. Press the PTT of Mobile-1 to access the system.
•
Originating CIM (O-CIM), changes from Idle
Task “2” to Dial Tone Task “C”.
3. Release the PTT of Mobile-1.
•
Mobile-1 hears “Dial Tone” from O-CIM.
4. Press the PTT of Mobile-1.
5. When Mobile-1's transmit light is lit, enter 4-digits
of DTMF for the Unique ID of Mobile-2
(terminating mobile).
6. Release the PTT of Mobile-1.
•
Mobile-1 hears the “Confirmation Tone” from the
O-CIM confirming the acceptance of the digits.
•
O-CIM changes to the Ringing Task “D”.
•
Mobile-1 hears “Ringing Tone” from the O-CIM.
•
Originating SNM (O-SNM) changes from Idle
Task “2” to SNM Outgoing Task “8”.
•
Destination SNM (D-SNM) changes from Idle
Task “2” to incoming Seize Task “3”.
•
D-SNM changes from Incoming Seize Task “3”
to SNM Incoming Task “4”.
•
D-SNM changes to Incoming Channel Task “5”.
•
O-SNM changes to Outgoing Channel Task “9”.
•
Destination CIM (D-CIM) changes from Idle
Task “2” to Transmit Task “3”.
•
Mobile-2 hears “Ringing Tone”.
7. Press the PTT on Mobile-2.
•
D-CIM changes to Duplex Task “6”.
•
O-CIM changes to Transmit Task “3”.
•
Mobile-1 hears the voice of Mobile-2.
8. Release the PTT on Mobile-2.
•
D-CIM changes to Transmit Task “3”.
•
Mobile-1 is silent.
9. Press the PTT on Mobile-1.
•
O-CIM changes to Duplex Task “6”.
•
Mobile-2 hears the voice of Mobile-1.
10.Release the PTT on Mobile-1.
•
O-CIM changes to transmit Task “3”.
•
Mobile-2 is silent.
11. Press the PTT on Mobile-1.
12.Press DTMF “#” key for longer than 1 second.
•
O-CIM changes to the End Call Task “E”.
•
Mobile-1 hears the “End Call Tone”.
•
O-CIM changes to Idle Task “2”.
•
O-SNM changes to the Idle Task “2”.
•
D-SNM changes to the End Call Task “C”.
•
D-CIM changes to the End Call Task “E”.
•
Mobile-2 hears the “End Call Tone”.
•
D-CIM changes to the Idle Task “2”.
•
D-SNM changes to the Idle Task “2”.