Casio QV-8000SX - Manual (Page 116)

E-116
MESSAGES
Can’t play
PANORAMA
CF ERROR
You must format the
CompactFlash card
before using it with
this camera.
FORMAT
MENU
MESSAGES
MEMORY FULL
Change quality or
delete unneeded
images.
MEMORY FULL
Delete unneeded
images.
NO FORMAT
3. Use [+] and [–] to select “Yes”, and then press the
shutter button.
• Select MENU if you want to abort the reformat
procedure without deleting anything.
• Completion of the format operation is indicated by
the message “NO IMAGE” appearing on the
monitor screen. This message also indicates that
the memory card was formatted successfully.
Not enough memory for recording in the current
quality mode. Change to another quality mode, or
delete some images from the memory card (pages
E-53, 92).
• Not enough memory for further recording. Delete
some images from memory card (page E-92).
• DCIM folder or other file (page E-104) cannot be
created due to insufficient memory when down-
loading data from a computer to the memory card.
Use your computer to delete unneeded images to
free up memory card space for the images you are
downloading. You could also press the MENU
button and format the memory card in the camera,
but doing so deletes all image files currently
stored on the memory card.
The memory card is not formatted. Format the
memory card before trying to use it (page E-36).
There is no memory card installed in the camera.
This message appears when there is not enough
memory to perform panorama recording. Delete
some images from the memory card to make room
for the new image.
Perform the following procedure whenever a
memory card starts to behave abnormally.
Important!
The procedure described below deletes all im-
ages stored in the memory card. Make sure all of
your important images are backed up onto a
computer hard disk or other storage medium be-
fore performing this procedure.
To reformat a memory card
1. Connect the AC adaptor to the camera and switch
to AC power or load a new set of batteries into the
camera.
• Power failure while a format operation is being
performed aborts the reformat operation.
2. Press MENU.