Casio QV-8000SX - Manual (Page 42)

E-42
POWER SUPPLY
• Always be sure to use the AD-C620 AC adap-
tor only. Using any other AC adaptor can cause
damage to the camera not covered by the war-
ranty.
• When unplugging the AC adaptor from the wall
socket, be sure to grasp the adaptor (not the
cord).
• Avoid any undue bending, pulling, and twisting
of the AC adaptor’s cord, and never try to
lengthen the cord by splicing it with other wire.
CAUTION
• Be sure to turn power off before connecting or disconnect-
ing the adaptor.
• Always turn camera power off before disconnecting the AC
adaptor, even if the camera has batteries installed. If you
don’t, the camera will turn off automatically when you dis-
connect the AC adaptor. You also run the risk of damaging
the camera whenever you disconnect the AC adaptor with-
out first turning power off.
• The AC adaptor may become warm to the touch after ex-
tended periods of use. This is normal and is not cause for
alarm.
• After using the camera, turn it off and unplug the adaptor
from the AC outlet.
• The camera automatically switches over to AC adaptor
powered operation whenever the AC adaptor is plugged
into the camera.
• Always use the AC adaptor to power the camera whenever
it is connected to a computer.
Power Save Settings
The settings described below let you specify sleep and auto
power off trigger times that help to conserve valuable battery
power.
SLEEP .................. The monitor screen enters a sleep state
if no operation is performed for a speci-
fied amount of time in the Record Mode.
Pressing any button restores full power.
You can specify 30 seconds, 1 minute,
or 2 minutes before the sleep state is
triggered, or you can turn off this setting
entirely.
AUTO
POWER OFF ........ Auto Power Off turns off camera power if
no operation is performed for a specified
amount of time. You can specify 2 min-
utes, 5 minutes, or 10 minutes before
AUTO POWER OFF is triggered, or you
can turn off this setting entirely.
• AUTO POWER OFF takes priority when both SLEEP and
AUTO POWER OFF are both set for a 2-minute trigger
time. This means camera power turns off if no operation is
performed after two minutes.
CAUTION