Epson Action Laser II - Manual (Page 105)

Using the SUB CONFIG Option
FORM TOP
0.50
0.50-1.50 (inch)
This option specifies
the
distance from the top of the
sheet to the
baseline of
the
first printable line. This is measured in 0.05-inch
increments. The factory setting is 0.50 inches.
TEXT 66LINES
1 to available
Use this option to set the page length. The unit of measure for this
option is 1/6th of
an
inch. If you change the ORIENT, P-SIZE, or
FORM TOP settings with SelecType, the form length setting
automatically returns to the default setting for each paper size. The
factory
setting
is 62 (line spacing 6 lines per inch).
SKIPBOTTOM OFF
*OFF
ON
When SKIPBOTTOM is set to on, the printer inserts the number of
line spaces specified by the ESC N (skip-over-perforation) command
between the last line printed on one page and the first printable line
on
the next
page. The total number of lines skipped equals the
FORM TOP setting plus the amount of skip-over-perforation set
with ESC N. Since most application programs insert their own top
and bottom margins, you should use this feature only if your
program does not provide them.
SelecType 4-41