Epson Action Laser II - Manual (Page 151)

Status and Error Messages
[E] RESELECT TRAY
The optional multi-media feeder is not installed and the INPUT
option is set to OPT or AUTO. Install the optional multi-media
feeder and then press
CONTINUE.
However, if you decide not to
use the optional multi-media feeder, simply press
CONTINUE
and
paper is automatically selected from the standard paper cassette.
[S] RESET
The printer has been reset to previous settings to the macro
number specified with the LOAD MACRO setting in the
SYSTEM CONFIG option of SelecType Level 1.
[S] ROM Check
The printer is checking ROM.
[E] SAVE MEMORY OVERFLOW
This message may appear when you are trying to save a macro
with the SYSTEM CONFIG option SAVE MACRO setting in
SelecType Level 1. The printer does not have enough memory to
save any additional macros. To correct this error, delete unused
macros using the DELETE MACRO setting, and then repeat
SAVE MACRO.
[E] SERVICE REQ. CXXX
[E] SERVICE REQ. E00XX
A controller or print engine error has been detected. Write down
the error number that appears in the right column of the display
and turn off the printer. Turn the printer back on after a few
seconds to see if the error message still appears. If it does, turn
off the printer, unplug the power cord from the electrical outlet,
and contact a qualified service person.
[E] SET [paper size] MANUAL
This message requires that you set the paper size for manual
feeding.
[E] STARTUP ERROR
Press to continue.
7-6 Troubleshooting