Silvercrest SDDD 7 A1 - Manual (Page 137)

SilverCrest SDDD 7 A1
English - 135
1. Attaching the mounting plate (D) to the headrest
 Open the strap's clip fastener on the back of the
mounting plate.
 Position the rear, padded side of the mounting
plate as flat as possible against the back of the
headrest. The clip fastener should be at the
bottom.
 Pull the 2 straps over the headrest and click
these into place in the clip fastener at the
bottom of the mounting plate.
 These can be pulled tight using the adjustment
systems on the straps, thereby ensuring secure
seating of the mounting plate (D).
2. Attaching the DVD player (A) / monitor (B) to the mounting plate (D)
 There are 4 mounting bolts on the back of the
devices (A, B).
 Place the device (A, B) on the mounting plate
(D) so that the 4 mounting bolts in the upper
(rounded) section catch on to the 4 notches in
the mounting plate (D). To do this the device
must be gently pressed against the spring bolts
on the mounting plate (D).
 Now press the device (A, B) downwards
approx. 1cm until the locking bolt located in the
upper middle of the back of the mounting plate
(D) clicks into place.
 Check that the locking bolt is correctly engaged
by tested whether or not the device (A, B) can
be lifted out of the 4 notches and removed
again. If this is not possible then you have
successfully attached your device (A, B) to the
mounting plate.
 You may now connect any necessary cables.