Silvercrest SEAD 1800 B1 - Manual (Page 8)

6
4.8 Material damage
Warning! Follow the instructions below to
prevent material damage.
• Never operate the appliance without
water or liquid.
• Make sure there is never too much liquid in
the appliance. The level of liquid must
always be below "MAX". If there is too
much liquid, the appliance might overflow.
• Only place the appliance on a level, dry,
non-slip surface so that the appliance can
neither fall over nor slide off.
• Do not place the appliance immediately
underneath a suspended cupboard, as
steam escapes upwards and might
damage the furniture.
• Do not place the appliance on a hot
cooking ring.
• The appliance and accessories may not
be put in a microwave oven.
5. Unpacking and setting up
Note: As the appliance is supplied with a
thin film of grease, there might be a small
amount of smoke and odour the first time it is
used. This is not harmful and will stop after a
short time. Please ensure adequate
ventilation during this process.
1. Remove the individual parts from the
packaging.
2. Check that the individual parts are
complete (see “1.2 Scope of supply” on
page 2) and are undamaged.
3. Clean the appliance thoroughly before
using it for the first time (see
“9. Cleaning and storing” on page 12).
4. Unwind the mains cable 8 from the
cable store over its entire length.
5. Place the appliance on a level, dry, non-
slip surface so that the appliance can
neither fall over nor slide off.
6. Insert the power supply plug in a
suitable earthed mains socket (see
“3. Technical data” on page 3).
7. Add around 5 l water to the container 3.
8. Allow the water to boil for around 20
min (see “6. Operating the appliance”
on page 6).
9. Pour the water away.
The appliance is now ready to use.
6. Operating the appliance
6.1 Adjusting settings, switching on and
off
Note: As soon as you turn the rotary
knobs 7 or 6, the background illumination
for the displays will switch on automatically.
The light for the displays switches off again
automatically after 5 minutes.
Warning! Only connect the
appliance to an earthed mains
socket, as protection against
electric shock depends on this.
1. Insert the power supply plug in a
suitable earthed mains socket (see
“3. Technical data” on page 3).
RP89015 Einkochautomat LB4 Seite 6 Dienstag, 12. März 2013 4:19 16