Silvercrest SIUR 10 A1 - Manual (Page 143)

140 SIUR 10 A1
GB
♦ Use the i /i control points / on the device or the i /i keys /
on the remote control to select the hour for the required alarm time. Next, touch
the
control point or press the i key on the remote control.
♦ The alarm time minute display will now blink. Use the i /i control
points
/ on the device or the i /i keys / on the remote
control to select the minute for the required alarm time. Next, touch the
control point or press the i key on the remote control.
♦
AL OUT
will now appear on the display, and you can select the required
alarm function or deactivate the alarm setting. Use the i /i control
points
/ on the device or the i /i keys / on the remote
control to select the required alarm function:
iPort play: Signal tone: Radio: Deactivated:
♦ Touch the control point or press the i key on the remote
control to complete the setting.
NOTE
► If approx. 15 seconds passes without any changes taking place during
setting, the device cancels the alarm setting.
When the alarm time is reached
In the case of the "iPort play" setting, the device connected to the iPort will
be started for 60 minutes with increasing volume.
In the case of the "Signal tone" setting, a signal tone will be sounded with
increasing volume. The duration of the signal is limited to 10 minutes.
In the case of the "Radio" setting, the radio will be switched on. The previously
selected station will be activated for a maximum of 60 minutes at an increasing
volume.
♦ Touch the SNOOZE control point to stop the alarm for 10 minutes.
The alarm number will blink for this period. A renewed alarm will sound
after 10 minutes.
NOTE
► The repeat alarm function is possible up to 60 minutes after the set wake
time is reached.
♦ Press any button to stop the current alarm, even if the key lock is switched on.
IB_86209_SIUR10A1_LB1.indb 140 IB_86209_SIUR10A1_LB1.indb 140 11.03.13 09:21 11.03.13 09:21