Rose Electronics CrystalView Pro Fiber - Manual (Page 16)

10
CRYSTALVIEW PRO FIBER
INSTALLATION AND OPERATIONS MANUAL
The receiver will always generate an exact reproduction of the source
signal (up to the max resolution of the unit) if the Fixed Resolution is set
to “OFF”.
The fixed resolution setting should be used if the monitor resolution on the
receiver is not capable of displaying the resolution sent by the transmitter.
If the transmitter is connected to a KVM switch with several computers
with different video resolutions, setting the receiver to a fixed resolution
eliminates the need for the receiver to adjust to the sent resolution when
switching between computers. The received image will display faster
when switching between computers if you use a fixed resolution setting.
You can increase of decrease the fixed resolution with a VGA input source
but only increase the resolution with a DVI input source. Decreasing the
resolution of a DVI source has no effect.
Use the arrow keys to select the needed fixed resolution and refresh rate
and then press enter to accept the new setting.
NOTE: Refresh rates of 60Hz are best for LCD displays, 75Hz for CRT’s.
The Brightness / Contrast menu allows you to adjust:
Brightness Contrast Back level
Figure 6. Brightness/Contrast menu
Use the arrow keys to select the brightness, contrast, or back level Icon
and press enter. An adjustable scroll bar will display.
Click on “+“or “-” to increase or decrease the setting.