Amprobe DM-111S Current-Data-Logger - Manual (Page 21)

DMIIIS
EN - 19
5.4. ANALYZER MEMORY
This option permits you to display:
 The present content of the instrument memory
 The size of the memorized data
 The residual space available for future recordings (expressed in days and hours)
All the stored data can be displayed only if downloaded to a PC with the operating
software.
After selecting “ANALYZER MEMORY” from the Main Menu the screen below will be
displayed
ANALYZER MEMORY
01 Smp 02.01 01:23
02 Rec 02.01-02.01
03 R&a 02.01-02.01
04 Rec 02.01-02.01
05 R&a 02.01-02.01
06 Rec 04.01-05.01
DATA SIZE:0.11Mb
REC TIME: 0d.06h
 
LAST ALL
Example of ANALYZER
MEMORY screen
 Rec:
recordings effected with respective Start and Stop dates expressed in
the format “day.month” (start) – “day.month” (stop) without Voltage Sag
and Surge detection.
 R&a:
recordings effected with respective Start and Stop dates expressed in
the format “day.month” (start) – “day.month” (stop) with Voltage Sag and
Surge detection.
 Smp:
values of the samples of voltage and current stored by pressing SAVE.
 DATA SIZE: dimensions of the data saved in the instrument memory.
 REC TIME: amount of memory available, calculated on the basis of the parameters
selected for recording, therefore the most complete one (expressed in the
format “days.hours”) to make recordings.
The maximum quantity of Rec + R&a + Smp which can be contained by the instrument is 35.
Following keys are enabled:
 F1, F2:
(only if the quantity of Rec+R&a+Smp is higher than 7) to run over all
the recordings stored in the instrument memory.
 F3: to cancel the last recording effected.
 F4: to cancel all the recordings effected.