Amprobe DM-111S Current-Data-Logger - Manual (Page 37)

DMIIIS
EN - 35
6.4.2. "METER" mode
On rotating the switch to this position the instrument selects automatically the METER
mode corresponding to one of the below screens according to the settings made as per
paragraph 5.2.
27.09.00 17:35:12 27.09.00 17:35:12 27.09.00 17:35:12
ENERGY
SINGLE PH ASE
Ea1 = 0.000 kWh
Erc1 = 0.000 kVARh
Eri1 = 0.000 kVARh
Es1 = 0.000 kVAh
P1 = 36.38 kW
Q1 = 6.375 kVAR
S1 = 36.94 kVA
Meas Time: 00:00:00
ENERGY
THREE PHASE
Eat = 0.000 kWh
Erct = 0.000 kVARh
Erit = 0.000 kVARh
Est = 0.000 kVAh
Pt = 36.38 kW
Qt = 6.375 kVAR
St = 36.94 kVA
Meas Time: 00:00:00
ENERGY
THREE PHASE
Eat = 0.000 kWh
Erct = 0.000 kVARh
Erit = 0.000 kVARh
Est = 0.000 kVAh
Pt = 167.7 kW
Qt = 30.47 kVAR
St = 170.4 kVA
Meas Time: 00:00:00
Meas Meas ChgP Meas
Example of screen in single-
phase mode
Example of screen in “3 wires”
three-phase mode
Example of screen in “4 wires”
three-phase mode
The symbols used are described in Tab. 4.
For eventual messages displayed see Appendix 1
– MESSAGES DISPLAYED.
Following keys are enabled:
 F2:
to start / stop immediately a direct energy measurement. The energy
counters will start increasing proportionally to the active power
absorbed by the load.
The results obtained cannot be memorized.
If the active power is negative the counters will not increase.
 F1: (only for 4 wires measurement) to display the following screen. On the
basis of the settings made as per paragraph 5.2 following screens are
displayed cyclically:
Overall three-phase values, values of phase 1, phase 2 and phase 3
 SAVE:
to save in the instrument memory a record of “Smp” type (see
paragraph 5.4) containing the instantaneous values of voltage and
current present on the instrument inputs. This function is disabled
during a recording.
 ENTER/HOLD: to enable/disable the HOLD function (updating interruption) of the
displayed data. All the previous functions remain however available.
When the HOLD function is enabled, the word
HOLD is displayed.
When this function is enabled it’s not possible to record or take an
energy measurement. This function is disabled during a recording or
an energy measurement.
 MENU: to enter in the MENU mode and change the instrument settings (see
paragraph 5.2 and 5.3
). It’s not possible to enter the configuration
MENU during a recording or an energy measurement.
 START/STOP: to record selected parameters according to the instrument’s settings
(see chapter 7).