Electro-Voice 1252 - Manual (Page 87)

Electro Industries/GaugeTech
Doc # E107706 V1.25
6-3
6.3: Dynamic Readings Mode
Q The External Display puts itself in the Dynamic Readings Mode upon power-up. Use the MODE
button to access the Dynamic Readings from other Modes. Use the UP/DOWN arrows to navigate
from Group to Group within this Mode. See section 6.4 for a navigational map of the Dynamic
Readings Mode.
Q Group 1: Phase to Neutral Voltages (Use the LEFT/RIGHT arrows to access the following
readings, in order.)
• Volts AN/BN/CN
• Maximum Volts AN/BN/CN
• Minimum Volts AN/BN/CN
• Volts AN/BN/CN %THD
• Volts AN/BN/CN Maximum %THD
• Volts AN/BN/CN Minimum %THD
Q Group 2: Phase to Phase Voltages (Use the LEFT/RIGHT arrows to access the following readings,
in order.)
• Volts AB/BC/CA
• Maximum Volts AB/BC/CA
• Minimum Volts AB/BC/CA
Q Group 3: Current (Use the LEFT/RIGHT arrows to access the following readings, in order.)
• Current A/B/C
• Maximum Current
• Minimum Current
• Current %THD
• Current Maximum %THD
• Current Minimum %THD
• Current Calculated N/Measured N
• Maximum Current Calculated N/Measured N
Q Group 4: Watt/VAR (Use the LEFT/RIGHT arrows to access the following readings, in order.)
• kWatt/kVAR
• Maximum +kWatt/+kVAR/CoIn kVAR
• Maximum -kWatt/-kVAR/CoIn kVAR
• Block (Fixed) Window Average Maximum +kWatt/+kVAR/CoIn kVAR
• Predictive Rolling (Sliding) Window Maximum +kWatt/+kVAR/CoIn kVAR
Q Group 5:VA/PF/Frequency (Use the LEFT/RIGHT arrows to access the following readings, in
order.)
• kVA/PF lag/Hz
• Maximum kVA/Hz
• Minimum kVA/Hz