PLANET UMG-1000 - Manual (Page 11)

11
2.1 Hardware Installation
2.1.1 Removing the Chassis Cover
ƒ The screws around the cover are used to secure the cover to the chassis. Remove
these screws and put them in a safe place for later use.
ƒ Slide the cover backward then remove it from the chassis.
2.1.2 The Hard Disk Installation
The 2.5” SATA HDD is necessary for system operating. Please install at least 80G HDD
before system configurations.
ƒ Remove the drive bay from the chassis.
ƒ Insert the provided dampers on the sides of the drive bay.
L
Caution
Prior to removing the chassis cover, make sure the unit’s
power is off and disconnected from the power sources to
prevent electric shock or system damage.
2. Hardware Installation