ProSoft Technology RLX2-IFH9E - Manual (Page 114)

Dialog Boxes ControlScape ♦ RadioLinx
User Manual RadioLinx® ControlScape FH
Page 114 of 132 ProSoft Technology, Inc.
March 16, 2011
8.29 Radio Status Dialog Box - Remote Radio
The Radio Status dialog box opens when you select a remote radio (a radio
connected wirelessly to the RadioLinx network) in Diagnostic mode. Use this
dialog box to view the current status of the selected radio.

Radio Name: The name of the radio, configured on the Radio Configuration
dialog box.

Address: This radio's address on the network. The master radio is always 1.

Serial Number: This is the radio’s serial number.

Firmware Version: The radio’s firmware version. All radios on the network
must use the same firmware version.

Hardware: The radio’s hardware version.

FPGA: the version number of the Field Programmable Gate Array logic in the
radio. This logic determines the hardware characteristics of the radio.

Baudrate: The configured baud rate for this radio.

Channel Number: The configured channel number for this radio. All radios
on the network must use the same channel number.

Network Type: This is the network type configured on the Network
Properties dialog box.

Signal / Noise: Signal-to-Noise value is the ratio of Signal-Strength to Noise-
Strength.

Signal Strength (RSSI): The current signal strength (Received Signal
Strength Indicator) in dBm. The graph to the right of this field shows the
signal strength relative to 100%.

Link Status: The Link Status indicator changes color according to the quality
of the link:
o
Red: Poor
o
Yellow: Fair
o
Green: Good

Messages: indicates if the radio is responding or not.

OK: Click the OK button to save your selection and close the dialog box.