ProSoft Technology RLX2-IFH9E - Manual (Page 9)

ControlScape ♦ RadioLinx ControlScape FH
RadioLinx® ControlScape FH User Manual
ProSoft Technology, Inc. Page 9 of 132
March 16, 2011
1 ControlScape FH
The RadioLinx ControlScape FH Setup Application provides a user interface for
the configuration and maintenance of a radio network. It graphically (page 20)
reflects the physical layout of the component radios.
The Setup Application provides a means to:

Configure new networks (page 75) and radios (page 40):
o
assign roles (Master, Remote or Repeater) to the radios.
o
define data paths
o
set the radio’s operation parameters (baud rate, parity, IP Address and so
on)

Edit existing networks (page 46) or radios (page 40, page 49):
o
add or delete Remote or Repeater radios
o
re-assign roles to the radios.
o
define operation parameters

Diagnose functionality of existing networks (page 51, page 52).
o
display the status of each REMOTE or REPEATER radio (when a
MASTER radio is cabled to the PC)
Note: ProSoft Technology, recommends that the RadioLinx ControlScape FH Setup Application be
installed on only one computer and that the network configuration be done only from that one
computer. When a network is designed, configuration settings are stored in a database in the
RadioLinx ControlScape FH Setup Application. When networks are modified, the RadioLinx
ControlScape FH Setup Application depends upon the retrieval of the network’s configuration
history. Network modification and maintenance is easier if the RadioLinx ControlScape FH
Application Software is installed on only one computer. All subsequent network-related
configurations are done using that one computer.
The computer where the RadioLinx ControlScape FH Setup Application has been
installed will be referred to as the Configuration PC throughout this
documentation.