Important safety information – Epson MovieMate 30s User Manual
Page 68
68
Specifications and Notices
Important Safety Information
Follow these safety instructions when setting up and using MovieMate:
■
Except as specifically explained in this User’s Guide, do not attempt to service this product
yourself. Refer all servicing to qualified service personnel.
■
Never open any cover on the projector, except the lamp and filter covers. Dangerous electrical
voltages inside the projector can severely injure you.
■
The projector and its accessories come packaged in plastic bags. Keep plastic bags away from small
children to avoid any risk of suffocation.
■
Never look into the projector lens when the lamp is turned on; the bright light can damage your
eyes. Never let children look into the lens when it is on.
■
Don’t place the projector on an unstable cart, stand, or table. Also, don’t stand on the projector or
place heavy objects on it.
■
Never push objects through the cabinet slots or spill liquid into the projector.
■
Do not use the projector near water, or sources of heat or vibration. Do not expose it to rain or
moisture.
■
Do not move the unit during playback.
■
Do not touch the projection lens with bare hands.
■
Use a damp cloth for cleaning. Do not use liquid or aerosol cleaners. Unplug the projector from
the wall outlet before cleaning.
■
Never try to remove the lamp immediately after use. Doing so will result in serious burns. Before
removing the lamp, turn off the projector and wait approximately one hour for the lamp to cool
completely.
■
The lamp is fragile and can easily break. If the lamp breaks, handle the projector with extreme care
to avoid injury from broken glass, and contact Epson to replace the lamp.
■
Do not use the lamp after the lamp replacement period has elapsed, because the possibility of lamp
breakage increases. When the lamp replacement message appears, replace the lamp with a new one
as soon as possible.
■
The lamp in this product contains mercury. Please consult your state and local regulations
regarding disposal or recycling. Do not put in the trash.
■
The lamp in this projector is under high internal pressure and may make a loud noise if it breaks.
If it breaks, ventilate the room to prevent mercury gas inside the lamp from being inhaled or
coming into contact with the eyes or mouth.
■
Do not bring your face close to the projector while it is in use, to prevent inhaling or contact with
the gases inside the lamp if it breaks.
■
If the lamp breaks and gas from the lamp or fragments of broken glass are inhaled or get into the
eyes or mouth, or if any other ill effects are noticed, immediately seek medical advice.
■
Use the type of power source indicated on the projector. If you’re not sure of the power available,
consult the power company.