HP 300X - Manual (Page 12)

1-6 Introduction
Setting Up Your Network Printer
Note If you are on a network that uses TCP/IP, you must
configure the print server with an IP address and
other TCP/IP parameters as required. Check with
your network administrator for a valid IP address
and other required parameters.
The HP JetDirect CD-ROM contains software to quickly set up your
printer for the network environments summarized below.
See Chapter 4 in this guide for other available HP solutions.
For additional printer setup options and more information, see the HP
JetDirect Print Servers Administrator’s Guide (600N/400N/500X/
300X) included on the HP JetDirect CD-ROM.
Network System HP JetDirect CD-ROM Software
Microsoft networks
(IP or IPX)
Windows 95/98,
Windows NT 4.0,
Windows 2000
Use the HP Install Network Printer
wizard (see Chapter 3) for client-server
or peer-to-peer (direct-mode) printing.
For client-server networks, share the
printer on the server so that it’s
available to clients.
Novell NetWare
NDS or Bindery
networks (Queue
Server Mode only)
(IPX)
Windows 95/98,
Windows NT 4.0,
Windows 2000
Use the HP Install Network Printer
wizard (see Chapter 3) to set up the
appropriate queues on the NetWare
server and JetDirect print server.
UNIX networks
(IP)
HP-UX,
Sun Solaris Use the HP JetDirect Printer Installer
for UNIX (see the documentation and
release notes on the CD-ROM)
qsF00_en.book Page 6 Monday, June 26, 2000 3:15 PM