Resetting to factory defaults, Resetting to factory defaults -8 – HP 300X User Manual
Page 34
Advertising
3-8 Installing External Print Servers
Resetting to Factory Defaults
Once you configure your print server, the configuration settings are
retained in memory unless you manually reset them to factory defaults.
(The firmware is not affected when you reset the configuration
settings.)
To reset the print server to factory defaults, follow these steps:
1. Unplug the power cord from the print server.
2. While holding down the Test button on the print server, plug the
power module into the print server and continue to hold down the
Test button for about five seconds. Any user-configured settings
will be erased.
qsF00_en.book Page 8 Monday, June 26, 2000 3:15 PM
Advertising