HP 300X - Manual (Page 23)

Installing 600N (EIO) Internal Print Servers 2-9
Internal Print
Servers
2
Resetting to Factory Defaults
You can restore default values by performing a cold reset on your
printer (see your printer documentation for instructions). To perform
a cold reset on many HP LaserJet printers, turn off the printer and
then hold down
[Go] as you turn the printer back on.
CAUTION This restores both your printer and JetDirect
configuration to their factory default values.
CFG TCP/IP=NO* Selects whether you want to access the TCP/IP menu
and set TCP/IP protocol parameters. You must change
this to YES* each time you want to access the TCP/IP
menu.
In the TCP/IP menu, you can specify BOOTP=YES* for
TCP/IP parameters to be automatically configured by a
BootP or DHCP server when the printer is turned on.
If you specify BOOTP=NO, you can manually set the
following TCP/IP parameters from the control panel:
■ Each byte of the IP address (IP)
■ Subnet Mask (SM)
■ Syslog Server (LG)
■ Default Gateway (GW)
■ Idle Timeout period (default is 90 seconds, 0
disables the timeout)
CFG ETALK=NO* Selects whether you want to access the EtherTalk
menu and set the AppleTalk phase parameter (ETALK
PHASE=1 or 2) for your network. You must change this
to YES* each time you want to access the EtherTalk
menu.
JetDirect Menu Item Description
qsF00_en.book Page 9 Monday, June 26, 2000 3:15 PM