HP 300X - Manual (Page 22)

2-8 Installing 600N (EIO) Internal Print Servers
HP JetDirect EIO Control Panel Menu
Although use of the HP installation software is preferred, you can
configure basic network parameters on an HP JetDirect EIO print
server from the control panel on supported peripherals. For specific
instructions on using your peripheral’s control panel to access the
JetDirect EIO menu, refer to your peripheral’s documentation.
JetDirect Menu Item Description
CFG NETWORK=NO* Selects whether or not you want to access the JetDirect
menu items. NO* (default) indicates you do not want to
access the menu. You must change this to YES* each
time you want to access the JetDirect EIO menu.
Note: the asterisk (*) is used on some printers to
indicate the active selection.
IPX/SPX=ON*
DLC/LLC=ON*
TCP/IP=ON*
ETALK=ON*
Identifies whether the protocol stack is enabled or
disabled. The default is ON*. Change this to OFF* to
disable this protocol.
CFG IPX/SPX=NO* Selects whether you want to access the IPX/SPX menu
and set IPX/SPX protocol parameters. You must
change this to YES* each time you want to access the
IPX/SPX menu.
In the IPX/SPX menu, you can specify the Frame Type
parameter used on your network.
■ The default is AUTO, to automatically set and limit
the frame type to the one detected.
■ For Ethernet cards, frame type selections include
EN_8023, EN_II, EN_8022, EN_SNAP.
■ For Token Ring cards, frame type selections
include TR_8022, TR_SNAP.
In the IPX/SPX menu for Token Ring cards, you can
also specify
NetWare Source Routing parameters,
which include SRC RT=AUTO (default), OFF, SINGLE
R, or ALL RT.
qsF00_en.book Page 8 Monday, June 26, 2000 3:15 PM