HP 300X - Manual (Page 25)

Installing 600N (EIO) Internal Print Servers 2-11
Internal Print
Servers
2
Jumpers
The HP JetDirect 600N 10/100Base-TX card has configuration jumpers
that should be used only if the print server fails to link on the network.
The factory-default setting (P1 = Auto) will suit most installations.
When P1 is set to Auto, the other two jumper settings are ignored; the
print server auto-negotiates the link speed and duplex setting with the
connected switch or hub device. Even with devices that don’t auto-
negotiate, the print server detects the network link speed and uses
half duplex.
If the print server fails to link, you can manually configure the print
server by positioning the jumpers as shown below, only if you are
certain of the duplex setting and speed at which the switch or hub is
operating.
Link setting is auto-negotiated (default)
Link setting is 100Base-TX Half-Duplex
Link setting is 100Base-TX Full-Duplex
Link setting is 10Base-T Half-Duplex
Link setting is 10Base-T Full-Duplex
qsF00_en.book Page 11 Monday, June 26, 2000 3:15 PM