Husqvarna HUSKYSTAN C20 - Manual (Page 59)

59
4. Use the arrow “ “ or “ “ button to check what
you have programmed.
5. Press the “ “ button to leave the memory mode
and return to the Direct mode.
Attention: The selected pattern will be cleared from the memory module after closing
the machine if you do not press the “
“ button again when you have completed your
selection.
Adding patterns or letters
Clearing patterns or letters
While in the memory mode, press the “ “ button
or the “ “ button until the stitch number you have
selected is displayed, then add the new stitch or
change the stitch length, width, Auto-stop or mirror, if
desire.
If you wish to delete a certain stitch within in the
memory mode, use the “
“ button or “ “ button
until the actual stitch number is displayed.
Press the ” “ button to delete the selected pattern
and the following patterns in the program will move
back.