Honeywell 9900 - Manual (Page 85)

Dolphin® Power Tools User’s Guide Rev A
8/6/08
5 - 7
Powerout Enables and disables power out of the
serial port for ScanWedge specifically.
General power out settings are
established in the registry.
The serial port powers out 5V at
500mA.
0 0=Disabled; do not power out when
scanning with ScanWedge
1=Enabled; power out when
scanning with ScanWedge.
2=No change for ScanWedge. This
means that ScanWedge is not
altering the default power out
setting in the registry. The
terminal defaults to the power-out
setting in the registry.
EnablePrefixData Enables or disables all prefix data
received via COM port after a
successful scan.
All prefix data is defined in the Settings
Section (see page 5-3).
0 0=Disabled
1=Enabled
EnableSuffixData Enables or disables all suffix data
received via COM port after a
successful scan.
All suffix data is defined in the Settings
Section (see page 5-3).
0 0=Disabled
1=Enabled
Comm Section
The serial port settings in the Comm section determine the interaction between ScanWedge and the serial
port.
Comm Section
Key Description Default
Value Available Values