Humax DV-1000T - Manual (Page 26)

**
3.1 Booting Mode
When powering on your receiver for the first time, the mode selection will automatically appear.
Select DTV or DVD using the or DVD/DTV and press
the OK button.
Please wait for booting the DTV or DVD.
Note:
If you don’t select a specific mode, then the previous mode will
be automatically selected.
3.2 Installation Wizard
When using the DTV mode for the first time, a Channel Search will be performed automatically. (You
can run the Installation Wizard in Default Setting.)
1.Search
1. During operating search, the cursor is located at Stop.
Therefore, if you press the OK button during searching,
the operation is stopped and the channels found so far will
be displayed.
2. Even after the search operation is complete, and no or not
all channels are found, press the OK button and try to
reset the search operation again if necessary.
3. You can delete any unwanted channels from the list of
found channels. Select your desired channels to delete
and press the OK
button. Then select Delete and
press the OK button. To delete all channels, select
Select All to select all channels, select Delete, and press
the OK
button.
4. After completing the Channel Search and deleting unwanted channels, select Save to save
the changes. When completing Channel Search, you can enjoy digital television.
Warning : If you exit the Install Wizard without fully completing the channel searching
procedures, you may not watch any broadcasting normally. In this case, you
can use the Installation Menu to configure your receiver as you like
**
3. Loading
GB 25
**
**
**
**
**
**
**
**
**
**
**
**
**
**