Hand Held Products 4620 - Manual (Page 10)

ii
Programming the Interface - Terminal ID Method............... 2-8
Supported Terminals............................................................. 2-9
Keyboard Country .............................................................. 2-11
Keyboard Style ................................................................... 2-13
Keyboard Modifiers............................................................ 2-14
RS-232 Baud Rate........................................................ 2-16
RS-232 Word Length: Data Bits, Stop Bits, and Parity2-17
RS-232 Receiver Time-Out.......................................... 2-18
RS-232 Handshaking ................................................... 2-18
Host ACK Selection..................................................... 2-19
Host ACK Enable......................................................... 2-20
Wand Emulation ................................................................. 2-21
Wand Emulation Connection ....................................... 2-21
Wand Emulation Data Block Size................................ 2-22
Wand Emulation Delay Between Blocks..................... 2-23
Wand Emulation Overall Checksum............................ 2-23
Wand Emulation Transmission Rate............................ 2-24
Wand Emulation Polarity............................................. 2-24
Wand Emulation Idle ................................................... 2-25
Chapter 3 - Basic System Operation
Cordless Base........................................................................ 3-1
RF (Radio Frequency) Module Operation............................ 3-1
Cordless Imager .................................................................... 3-1
System Conditions ................................................................ 3-2
Linking Process.............................................................. 3-2
Imager Is Out of Range .................................................. 3-2
Imager Is Moved Back Into Range ................................ 3-2
Out of Range and Back into Range with Data Accumulation
Mode On......................................................................... 3-2
Base Charge Mode................................................................ 3-3
Beeper and LED Sequences and Meaning............................ 3-4
IT4620 LED Sequences and Meaning ........................... 3-4
IT2020-5B LED Sequences and Meaning ..................... 3-4
Imager Modes ....................................................................... 3-5
Unlinking the Imager ..................................................... 3-5