Hand Held Products 4620 - Manual (Page 66)

3 - 10 IMAGETEAM™ 2020/4620 System Manual
Resetting the Standard Product Default Settings: All
Application Work Groups
The following bar code defaults all of the work groups to the factory settings.
The Menu Commands starting on page 12-6 list the standard product default
settings for each of the commands (indicated by an asterisk (*) on the
programming pages).
Resetting the Standard Product Default Settings:
Current Application Work Group
If you aren’t sure what programming options are in your imager, or you’ve
changed some options and want the standard product default settings restored,
scan the
Standard Product Default Settings: Current Application Group bar
code below.
The Menu Commands starting on page 12-6 list the factory default settings for
each of the commands (indicated by an asterisk (*) on the programming pages).
Note: Scanning this bar code also causes both the imager and the base to
perform a reset and become unlinked. Refer to "Imager Modes" on
page 3-5 for additional information.
Note: If your imager is in multiple imager mode and you scan either the current
or all application group default bar code, you will hear up to 30 seconds
of beeping while all imagers are re-linked from the base and the settings
are defaulted to * settings. The default interface is keyboard wedge and
the default imager mode is single imager locked link mode.
Standard Product Default Settings:
All Application Groups
Standard Product Default Settings:
Current Application Group