Hand Held Products 4620 - Manual (Page 75)

IMAGETEAM™ 2020/4620 System Manual 4 - 5
Imager Power Time-Out Timer
Note: The Imager Power Time-out Timer option only applies to Manual/Serial
Trigger.
When there is no activity within a specified time period, the imager enters low
power mode. Scan the appropriate Imager Power Time-Out bar code to change
the time-out duration (in seconds).
Note: Scanning zero (0) is the equivalent of setting no time-out.
If there are no trigger pulls during the “imager power time-out timer” interval, the
imager goes into power down mode. Whenever the trigger is enabled, the
“imager power time-out timer” is reset. If the imager is placed in the IT2020-5B
cradle and the battery is in the process of being charged, the imager will not go
into power down mode.
Note: When the imager is in power down mode, pull the trigger to power the unit
back up. There will be a set of power up beeps and a delay of up to a few
seconds for the radio to join. The imager will then be ready to use.
0 seconds
200 seconds
400 seconds
900 seconds
* 3600 seconds
7200 seconds