Hand Held Products 4620 - Manual (Page 187)

IMAGETEAM™ 2020/4620 System Manual 11 - 1
11
Utilities
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the Symbology Chart, included in the
Appendix
A , page A-1) for the single character code that identifies each symbology.) This
action first clears all current prefixes, then programs a Code I.D. prefix for all
symbologies. This is a temporary setting that will be removed when the unit is
power cycled.
Reset Imager
Scanning the following bar code clears temporary settings in the imager and
returns imager to normal operation. Scanning this bar code also causes the
imager to re-link with the base.
Show Software Revision
Scan the bar code below to output the current software revision, unit serial
number, and other product information for both the imager and base.
Show Data Format
Scan the bar code below to show current data format settings.
Add Code I.D. Prefix to
All Symbologies (Temporary)
Reset Imager
Show Revision
Data Format Settings