Hoshizaki REFRIGERATED PREP TABLE WITH RAISED RAIL 73168 - Manual (Page 52)

52
H. Removal and Replacement of Thermistors and Thermostat
CAUTION
1. The thermistors are fragile; handle very carefully.
2. Do not shorten or cut the thermistor leads.
1. Cabinet Thermistor
1) Remove the refrigeration system cartridge. Perform steps 1 through 16 in "IV.B.2.
Pump‑Down Procedure." Once the refrigeration system cartridge is out, proceed to
step 2.
2) Cut the cable tie holding the cabinet thermistor to the cabinet thermistor bracket.
Remove the thermistor. See Fig. 5.
3) Disconnect the thermistor wire connector (below the control box).
4) Install the new thermistor and secure it to the cabinet thermistor bracket. Connect the
thermistor connector.
5) Once the repair is complete, return to step 17 in "IV.B.2. Pump‑Down Procedure" for
refrigeration system cartridge replacement.
2. Defrost Thermistor
1) Remove the refrigeration system cartridge. Perform steps 1 through 16 in "IV.B.2.
Pump‑Down Procedure." Once the refrigeration system cartridge is out, proceed to step
2.
2) Remove the tape securing the defrost thermistor to the evaporator shroud. Cut the
cable tie holding the defrost thermistor to the shroud. Remove the defrost thermistor.
See Fig. 5.
3) Disconnect the defrost thermistor wire connector (below the control box).
4) Install the new defrost thermistor and secure to the evaporator shroud. Connect the
defrost thermistor connector.
5) Once the repair is complete, return to step 17 in "IV.B.2. Pump‑Down Procedure" for
refrigeration system cartridge replacement.
Fig. 5
Defrost Thermostat
Cabinet Fan
Motors
Cabinet Thermistor
Defrost Thermistor
Defrost Heater
Evaporator Shroud
Cabinet Thermistor Bracket