Honeywell FUSION - Manual (Page 114)

FUSION DVR Digital Recording and Transmission System
7–12
7.7 PTZ ADDRESS SETTING
Some protocols support software address settings. The following section explains
these settings.
RX Address 1 This option was added for a particular line of receivers that support 2
ID addresses. This is the first RX address.
RX Address 2 This option was added for a particular line of receivers that support 2
ID addresses. This is the second RX address.
Previous ID This option was added for a particular line of receivers that support 2
ID addresses. This option displays the current RX address ID.
New ID This option was added for a particular line of receivers that support 2
ID addresses. This option is for entering a new RX address ID.
Set ID This option was added for a particular line of receivers that support 2
ID addresses. This option is for setting the new RX address.
PT Driver
Address This option is for specifying the PTZ ID address that the PTZ is set
to. This option must be set correctly in order for the DVR to
communicate with the PTZ. This option can be beneficial when large
amounts of PTZ are chained together.
7.7.1 ACTIVATING THE PTZ STATUS ON CLOSE OPTION
1. Start by creating a Preset or Tour for the selected camera.
2. Select either Start Tour or Go To Preset.
3. Press OK or APPLY to save.