HP 3500 User Manual
Page 153
Control panel message
Description
Recommended action
REPLACE FUSER KIT
alternates with
To continue press
The fuser is near end of life and the
SUPPLIES LOW setting in SYSTEM
SETUP is set to STOP.
1.
Order the fuser kit.
2.
Press to continue printing. Printing
can continue until REPLACE
FUSER KIT is reached.
or
Press for help.
See
Supplies and accessories
for more
information.
REPLACE SUPPLIES
alternates with
For status press
At least one supply item is out and needs
to be replaced and another supply item is
either out or low.
1.
Press to identify which supplies
should be replaced.
2.
Press for help.
or
for
more information.
See
Supplies and accessories
for more
information.
REPLACE SUPPLIES
alternates with
To continue press
More than one supply item is low, and
the SUPPLIES LOW setting in SYSTEM
SETUP is set to STOP.
1.
Press to identify which supplies
should be ordered.
2.
Order the identified supplies.
3.
Press to continue printing.
See
Supplies and accessories
for more
information.
REPLACE TRANSFER KIT
For help press ?
The transfer unit is at end of life.
Press for help.
or
for more
information.
See
Supplies and accessories
for more
information.
REPLACE TRANSFER KIT
alternates with
To continue press
The transfer unit is near end of life and
the SUPPLIES LOW setting in SYSTEM
SETUP is set to STOP.
1.
Order the transfer kit.
2.
Press to continue printing.
See
Supplies and accessories
for more
information.
Request accepted
please wait
The printer has accepted a request to
print an internal page, but the current job
must finish printing before the internal
page will print.
No action necessary.
Resend
upgrade
The firmware upgrade was not completed
successfully.
Attempt upgrade again. You might need
to use the parallel port to send the
upgrade file.
Restoring
factory settings
The printer is restoring factory settings.
No action necessary.
Restoring...
The printer is restoring settings.
No action necessary.
ENWW
Control panel messages
141