HP 3500 - Manual (Page 65)

12. Press to save the setting.
13. Press M
ENU
to return to the Ready state.
Manually configuring TCP/IP parameters from the printer control panel
Use manual configuration to set an IP address, subnet mask, default gateway, syslog server,
and idle timeout.
Setting an IP address
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO 1.
7. Press to select EIO 1.
8. Press to highlight TCP/IP.
9. Press to select TCP/IP.
10. Press to select CONFIG METHOD.
11. Press to highlight MANUAL.
12. Press to select MANUAL.
13. Press to highlight MANUAL SETTINGS.
14. Press to select MANUAL SETTINGS.
15. Press to highlight IP Address:.
16. Press to select IP Address:.
Note The first of four sets of numbers is highlighted. Each set of numbers represents one byte of
information and has a range from 0 to 255.
17. Press the or arrow to increase or decrease the number for the first byte of the IP
address.
Note To cycle through the numbers faster, hold down the arrow button.
18. Press to move to the next set of numbers. (Press to move to the previous set of
numbers.)
19. Repeat steps 17 and 18 until the correct IP address is entered.
20. Press to save the setting.
21. Press M
ENU
to return to the Ready state.
Setting the subnet mask
1. Press M
ENU
to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
ENWW Network configuration 53