Replacing supplies and parts, Locating supplies and parts, Supply replacement guidelines – HP 3500 User Manual
Page 122: Changing print cartridges
Replacing supplies and parts
Carefully follow the guidelines in this section when replacing printer supplies or parts. The
transfer unit, fuser, and pickup roller are printer parts designed to last the lifetime of the
printer. However, if these parts become damaged, they should be replaced.
Locating supplies and parts
Supplies and parts are identified by labeling and blue plastic handles.
The following figure illustrates the location of each supply item and part.
Supply item and part locations
1
fuser
2
print cartridges
3
transfer unit
4
pickup roller
Supply replacement guidelines
To facilitate the replacement of supplies, keep the following guidelines in mind when setting
up the printer.
●
Sufficient space is required above and in the front of the printer for removing supplies.
●
The printer should be located on a flat, sturdy surface.
For instructions on installing supplies, see the installation guides provided with each supply
item or see more information for the HP Color LaserJet 3500 series printer at
and for the HP Color LaserJet 3700 series printer at
CAUTION
Hewlett-Packard recommends the use of HP products in this printer. Use of non-HP products
may cause problems requiring service that is not covered by the Hewlett-Packard warranty or
service agreements.
Changing print cartridges
When a print cartridge approaches the end of useful life, the control panel displays a
message recommending that you order a replacement. The printer can continue to print
using the current print cartridge until the control panel displays a message instructing you to
replace the cartridge.
110
Chapter 7 Maintenance
ENWW