Hoshizaki MODULAR CUBELET SERENITY SERIES FS-1022MLH-C - Manual (Page 5)

5
Important Safety Information
Throughout this manual, notices appear to bring your attention to situations which could
result in death, serious injury, or damage to the unit.
WARNING Indicates a hazardous situation which could result in death or
serious injury.
CAUTION Indicates a situation which could result in damage to the unit.
IMPORTANT Indicates important information about the use and care of the
unit.
WARNING
This icemaker should be destined only to the use for which it has been
expressly conceived. Any other use should be considered improper and
therefore dangerous. The manufacturer cannot be held responsible for injury or
damage resulting from improper, incorrect, and unreasonable use.
To reduce the risk of death, electric shock, serious injury, or fire, follow
basic precautions including the following:
• This unit should be disassembled or repaired only by qualified service
personnel to reduce the risk of electric shock, injury, or fire.
• Move the power switch to the "OFF" position. Unplug the icemaker from the
electrical outlet and turn off the power supply to the condensing unit before
any servicing is undertaken. Place the disconnect (if applicable) in the off
position. Lockout/Tagout to prevent the power supply from being turned back
on inadvertently.
• Make sure the icemaker power switch is in the "OFF" position before plugging
in or unplugging the icemaker to reduce the risk of electric shock.
• Do not make any alterations to the icemaker or condensing unit. Alterations
could result in electric shock, injury, fire, or damage to the units.
For FS
• The icemaker requires an independent power supply of proper capacity. See
the nameplate for electrical specifications. Failure to use a properly sized
breaker or fuse can result in a tripped breaker, blown fuse, or damage to
existing wiring. This could lead to heat generation or fire.
• THIS UNIT MUST BE GROUNDED. This unit is equipped with a 3-prong
grounding plug to reduce the risk of potential shock hazards. It must be
plugged into a properly grounded, independent wall outlet. If the outlet is a
2-prong outlet, it is your personal responsibility to have a qualified electrician
replace it with a properly grounded, independent 3-prong wall outlet. Do not
remove the ground prong from the power cord and do not use an adapter plug.
• Do not use an extension cord.
• To reduce the risk of electric shock, make sure the power switch is in the "OFF"
position before plugging in or unplugging the unit.