Hoshizaki MODULAR CUBELET SERENITY SERIES FS-1022MLH-C - Manual (Page 55)

55
4) Pour the sanitizing solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to overflow into the drain pan.
5) Replace the spout and strap in their correct positions.
6) Allow the icemaker to sit for about 10 minutes before operation.
7) Replace the top panel in its correct position. Move the control switch to the "ICE"
position, then plug the unit back in. Move the power switch to the "ON" position, then
replace the front panel in its correct position. Make ice using the solution until the
icemaker stops making ice.
8) Remove the front panel, then move the power switch to the "OFF" position. Move the
control switch to the "DRAIN" position, then move the power switch back to the "ON"
position. Replace the front panel in its correct position.
9) Allow the water system to drain for 5 minutes.
10) Remove the front panel. Move the control switch to the "ICE" position, then replace the
front panel in its correct position.
11) Open the water supply line shut-off valve to supply water to the reservoir.
12) After the gear motor starts, remove the front panel. Move the power switch to the "OFF"
position. Move the control switch to the "DRAIN" position, then move the power switch
back to the "ON" position. Replace the front panel in its correct position.
13) Allow the water system to drain for 5 minutes.
14) Remove the front panel. Move the control switch to the "ICE" position, then replace the
front panel in its correct position.
15) Allow the icemaker to run for about 30 minutes, then remove the front panel. Move the
power switch to the "OFF" position, then unplug the unit from the electrical outlet.
16) Pour warm water into the dispenser unit/storage bin and melt any remaining ice. Clean
the dispenser unit/storage bin liner using a neutral cleaner. Rinse thoroughly after
cleaning.
17) Plug the unit back in. Make sure the control switch is in the "ICE" position, then move
the power switch to the "ON" position to start the automatic icemaking process.
B. Maintenance
This icemaker must be maintained individually, referring to the instruction manual and
labels provided with the icemaker. The schedule below is a guideline. More frequent
maintenance, however, may be required depending on water quality, the icemaker's
environment, and local sanitation regulations.
Consult with your local distributor about inspection and maintenance service. To obtain
the name and phone number of your local distributor, visit www.hoshizaki.com or call
Hoshizaki Technical Support at 1-800-233-1940 in the USA.
WARNING
1. Only qualified service technicians should attempt to service this icemaker.
2. Move the power switch to the "OFF" position and unplug the unit from the
electrical outlet before servicing.