Hoshizaki MODULAR CUBELET SERENITY SERIES FS-1022MLH-C - Manual (Page 57)

57
C. Preparing the Icemaker for Long Storage
CAUTION
When storing the icemaker for an extended time or in sub-freezing
temperatures, follow the instructions below to prevent damage.
When the icemaker is not used for two or three days under normal conditions, it is
sufficient to only move the power switch to the "OFF" position. When storing the icemaker
for extended time or in sub-freezing temperatures, follow the instructions below.
1. Remove the water from the icemaker water supply line:
1) Remove the front panel.
2) Move the power switch to the "OFF" position.
3) Close the icemaker water supply line shut-off valve, then open the icemaker water
supply line drain valve.
4) Allow the line to drain by gravity.
5) Attach a compressed air or carbon dioxide supply to the icemaker water supply line
drain valve.
6) Move the control switch to the "ICE" position, then move the power switch to the "ON"
position.
7) Blow the icemaker water line out using the compressed air or carbon dioxide supply.
8) Close the icemaker water supply line drain valve.
2. Drain the evaporator:
1) Move the power switch to the "OFF" position. Move the control switch to the "DRAIN"
position, then move the power switch back to the "ON" position. Replace the front panel
in its correct position.
2) Allow the water system to drain for 5 minutes.
3) Remove the front panel, then move the power switch to the "OFF" position.
4) Remove the evaporator drain line hose from the evaporator and attach a compressed
air or carbon dioxide supply to the hose.
5) Move the power switch to the "ON" position. Blow out the evaporator drain line using the
compressed air or carbon dioxide supply until water stops coming out.
6) Move the power switch to the "OFF" position, then reconnect the evaporator drain line
hose.
7) Move the control switch to the "ICE" position. Replace the front panel in its correct
position, then unplug the unit from the electrical outlet.
8) Remove all ice from the dispenser unit/storage bin. Clean the dispenser unit/storage bin
liner using a neutral cleaner. Rinse thoroughly after cleaning.