Harman Stove Company PB 105 - Manual (Page 27)

27 3-90-07205R19_05/13
1. Turn Mode Selector to “OFF”.
This resets the control in addition to turning it off.
Starting A Fire Automatically
Operation
2. Clean Burnpot with scraper, if necessary.
This is usually a weekly maintenance procedure.
Cleaning the burn pot with the scraper with a small
amount of new fuel in the bottom is not a problem.
First, scrape the ashes on the front of the burn pot
into the ash pan. Then scrape the hole grid surface
downward into the burn pot. When the stove is
ignited these scrapings will be pushed out by the
feeder.
The illustration at left shows the hopper swing plate
open for easy access to the burn pot. The burn pot
can also be reached through the firebox door.
NOTE: To minimize the amount of stress placed
on the hopper swing plate hinges, opening of
the hopper swing plate should be done with the
least amount of fuel in the hopper as possible.
3. Fill Hopper with pellets.
When filling the hopper check for excessive
fines in the bottom of the hopper. Fines are
small pieces of broken pellets (sawdust). Fines
do not flow easily and often build up on the
hopper funnel bottom angles. These fines can be
pushed into the feeder opening and then fill the
hopper with pellets. As the system works, they
will be burned.
Ash Pan Ash Pan Handle
Scrape burnpot to remove any carbon
build-up that may have occured