Harman Stove Company PB 105 - Manual (Page 28)

28 3-90-07205R19_05/13
4. If Starting After an empty Hopper, Turn Feed
Adjuster to “TeST” (for one 60 second cycle).
This will feed pellets into the auger tube and also
allow you to check the motors for operation.
NOTe:
The auger motor will not operate with any of
the doors open.
5.
Turn Feed Adjuster to #4.
If this is your first fire or you are trying different
pellets, set the feed adjuster to #4, This is an
average number for most pellets and may need
to be adjusted for your particular fuel. After you
know a feed rate setting that works well for your
application, use that setting.
NOTE: You know your feed rate is too high
when: The overheat safety feature is energized
each time the heating zone demand turns off
during a high burn. OR, If unburned or partially
burned pellets are found in the ash pan.(this
may also be an indication of a burn pot in need
of scraping.)
7. Turn the MAX. TeMP. dial on the control
board to the desired temperature. This setting
must always be at least 5° F. higher than the MIN.
TEMP. setting.
Operation
6. Flip the Igniter Switch up into the “AUTO”
position.
WARNING: HOT WHIle IN OPeRATION. KeeP
CHIldReN, ClOTHING, ANd FURNITURe
AWAY. CONTACT MAY CAUSe SKIN BURNS.
WATER TEMPERATURE
MAX. TEMP. MIN. TEMP.