Fostex D2424 - Manual (Page 105)

105
Model D2424 Reference Manual (Changing the Initial Settings <SETUP mode>)
Changing the Initial Settings (SETUP mode)
<Table-3> “Execution” menu
Execution item Display Refer page Community
Editing a program title Title Edit PGM** ? 37 -
Deleting a program Delete PGM** ? 36 -
Loading song data Load PGM ? 84 -
Saving song data Save PGM ? 84 -
Optimizing a Disk Disk Optimize ? 30 -
Formatting a Disk Disk Format ? 30 -
<Table-2> “Check” menu
Check item Display Refer page Community
Check of the Event number on the track NOs Of Event ? 122 -
Check of the current drive status Drive Info ? 127 -
<Table-1> “Changing the initial settings” menu
Parameters Display Default setting Refer page Community
Setting a time signature Signature Set ? 001bar 4/4 107
Setting a Tempo Tempo Map Set ? 001bar 1 120 109
Setting the metronome function Click ? Off 111
Setting a preroll time Preroll Time ? 00s 112
Setting MIDI sync output signal Midi Sync Out ? MTC 113
Setting an MTC frame rate Frame Rate ? 25 frame 113
Setting an MTC offset value MTC OFFSET 00h 59m 57s 00f 00sf 114
Setting Offset mode Offset Mode ? ABS 115
Setting a reference time code Ref. TC ? Void! Available with option Model 8345 (Refer to APPENDIX)
Setting the slave type Slave Type ? Vari 116
Setting the record protect function Rec Protect ? Off 116
Setting digital input tracks D. in? Analog 117
Setting digital output tracks D. out ? adat 118
Setting BAR/BEAT resolution mode Resolution ? Off 119
Setting the MIDI device ID number Device ID ? 00 120
Setting the operating clock Clock Sel ? Int. 121
Setting the SYNC preset Sync Preset ? Available with option Model 8345 (Refer to the APPENDIX)
Setting the Virtual LTC display Virtual LTC ? Available with option Model 8345 (Refer to the APPENDIX)
Setting the chase offset display Offset Disp ? Available with option Model 8345 (Refer to the APPENDIX)
Setting the internal clock Date & Time Set ? Please refer to the “Quick Operation Guide.”
Setting the Auto EE mode Auto EE Mode ? Off 123
Setting the Foot switch function Foot SW ? Punch IO 123
Setting the stop function at the mark point Mark Stop MD ? Off 124
Setting the reference level Ref. Level ? -12dB 125
Setting input/output Balance/Unbalance BAL/UNBAL ? UNBAL 126
Setting the drive Drive Sel. ? IDE 129 -
Setting the display contrast level Contrast ? Level 6 130
: Modes applicable program by program. They can be saved/loaded.
: Modes applicable to all programs. They cannot be saved/loaded.
The SETUP mode offers the Changing the initial settings menus to configure the operating environment
of the recorder, a “Check” menu that enables you to check the number of events of each track and the
“Execution” menus to execute certain operations such as save/load and disk formatting.
In this chapter we will explain procedures only on <Table-1> “Changing the initial settings” menu (except
setting the internal clock) and <Table-2> “Check” menu. To learn how to set the internal clock, refer to
the “Quick operation guide,” and on the “Execution” menu, the “Reference page” written in <Table-3>.