Fostex D2424 - Manual (Page 96)

Model D2424 Reference Manual (Saving and Loading Song Data)
96
Loading data saved on several removable disks
As an example here, we will load the data of a Program saved onto two removable disks.
1.Insert the first disk (Disk-1) into the SCSI device.
<Note>
Make sure that you insert the disks in the correct
order. If you insert the wrong disk, the recorder
displays "Wrong disk" -> "Illegal No!" and ejects the
disk. Follow the disk markings you made during the
save operation.
2.Follow Steps 1-3 of the “Loading Song data”
procedure.
The display flashes the number of the existing Backup
data in the SCSI disk, and then indicates that the first
disk has been inserted.
Rotating the [ JOG ] dial will toggle between “ B** ” and
“ Eject .” If you wish to cancel the load operation and
remove the disk, select “ Eject ” and press the [ EXECUTE/
YES ] key.
3.Press the [EXECUTE/YES] key.
A prompt inquiring whether to set a new program on
the current drive which is the load destination will
appear. ("
New PGM " appears and " SURE? " flashes.)
Turning the [ JOG ] dial in this state makes it possible to
select a program on the current drive. The size of the
program appears when the program is selected.
If you select a program that is already recorded with
data and load is executed for the load destination, the
existing data is deleted while loading takes place.
If you do not want to overwrite the existing data, select
“
New PGM ” mentioned above, prior to loading.
4.Press the [EXECUTE/YES] key after selecting the
program.
Loading is started and the display will show “ B** >> P**
***MB ”. This indicates that the backup data (B**) on
the SCSI hard disk is being loaded on the current drive
program (P**).
The “***MB” (load size) is counted down as loading
proceeds.
When Disk 1 loading is completed, an “ Insert Disk 2 ”
message appears, and Disk 1 is automatically ejected.
5.Insert Disk 2 (second disk) into the SCSI hard disk
drive according to what the display requests.
Loading automatically resumes when Disk 2 is inserted.
The display will show the same count down as shown
for Disk 1. The size of the program is counted down
along with the load process.
When all data is loaded, “ COMPLETED! ” lights up, and
the program time base (ABS 0) started up prior to going
into the SETUP mode will appear.
<Note>
You cannot abort a load operation on a SCSI device
while it is in progress.
6.Press the [EXIT/NO] key, or [STOP] button.
The “ COMPLETED! ” go off.
Flashing
Flashing Flashing
∞ 42
OL
0
30
24
18
12
9
6
3
kHz
24
FS
BIT
SETUP
24
∞ 42
OL
0
30
24
18
12
9
6
3
23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1
CLOCK
INT
∞ 42
OL
0
30
24
18
12
9
6
3
kHz
24
FS
BIT 24
∞ 42
OL
0
30
24
18
12
9
6
3
23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1
CLOCK
INT
SURE?