FUJITSU ScanSnap S510 - Manual (Page 41)

2.2 Connecting the ScanSnap to your PC
ScanSnap S510 Operator's Guide
21
Connecting t
he ScanSnap
2
2.2 Connecting the ScanSnap to your PC
Follow the procedure below to connect the ScanSnap to your personal computer.
1. Connect the ScanSnap to a power outlet with the AC cable.
2. Connect the ScanSnap to your personal computer with the USB cable.
The following describes each of the above two procedures.
■ Connecting the Power Cable
Connect the AC cable and adapter as shown below.
CAUTION
Do not use AC adapters other than the following.
Operation
1. Connect the AC cable to the AC adapter (collectively called the power cable).
ATTENTION
• Be sure to connect the AC cable to an outlet before connecting the USB cable.
• Be sure to install ScanSnap Manager into your personal computer before
connecting the ScanSnap to your personal computer. (For details about the
installation, refer to "Installing the Supplied Programs (page 6)").
Manufacturer AC-adapter model number
LEI NU40-2160250-I3
SANKEN ELECTRIC CO,. LTD SEB55N2-16.0x (x= A-Z or Blank)
ATTENTION
Use only the supplied AC cable and AC adapter (power cable).
AC cable
AC adapter