FUJITSU ScanSnap S510 - Manual (Page 43)

2.2 Connecting the ScanSnap to your PC
ScanSnap S510 Operator's Guide
23
Connecting t
he ScanSnap
2
■ Connecting the USB Cable
Connect the USB cable as shown below.
Operation
1. Remove the seal on the back side of the ScanSnap.
2. Connect the USB cable to the USB connector on the ScanSnap, and the other end of
the USB cable into the USB port on your personal computer.
Insert the USB cable into the connector all the way to the end.
ATTENTION
• Use only the USB cable supplied with the Scanner.
• When connecting to a USB hub, be sure to connect the ScanSnap to the hub
nearest your personal computer (first stage). If you connect it to a USB hub
from the second stage onwards, the ScanSnap may not function correctly.
• If you connect the ScanSnap with USB 2.0, it is required that the USB port and
the Hub be compliant with USB 2.0. The scanning speed may slow down
when you connect the ScanSnap with USB 1.1. If your computer has the USB
2.0 compatible port, use it.
DC 16V
Seal
USB cable
USB cable