Fujitsu Siemens Computers Connectivity Peripherals Point 1600 - Manual (Page 25)

Assembling the High-Usage Cradle 2-9
Figure 2-7. High-Usage Cradle Assembly
3. Determine which side the adjustment knob will be installed on. The knob can be installed on either
the right or left side of the cradle module to accommodate right- or left-handed users.
4. Install the #10 screw, lock washer, and nylon washer provided on one side (opposite the side where
the knob will be installed) to fasten the cradle module to the cradle base. (Do not tighten the screw at
this step.) Ensure that the nylon washer is installed closest to the cradle base as shown in Figure 2-7.
5. Install the knob and spacer on the desired side of the cradle. (Do not tighten the knob in this step.)
6. Tighten the screw (that you installed in step 4) to 1/2 turn past finger tight and install the cover over
the head of the screw as shown in Figure 2-7. To do so, remove the protective backing and apply the
adhesive side of the cover toward the cradle.
7. Install the cover label inside the cradle module as shown in Figure 2-7. To do so, remove the
protective backing and apply the adhesive side of the label toward the cradle module. (This covers
access holes in the cradle module that are not used in this assembly.)
Cradle
Module
Cradle
Base Cover
Screw
Nylon Washer
Spacer
Adjustment
Cover Label
Kensington Security Standard Slot
Knob
Star Washer