FUJITSU C150-E146-02EN - Manual (Page 29)

2-4
Repositioning the Shipping Lock
To keep the scanner from being damaged during shipping, the carrier unit is fixed with a Shipping Lock. After
placing the carrier unit where it will be installed, change the position of this Shipping Lock as explained below.
q Place the image scanner on the edge of the desktop so that the left side of the scanner (where ADF
is attached) extends from the desktop. Do not set the image scanner upside down or on its side.
CAUTION
Do not extend the scanner more than 20cm (8 in.) from the desk.
w Remove the shipping lock from position A. Then, install the shipping lock at position B.
CAUTION
Before moving or storing the scanner, make sure that the shipping lock is set to the
shipment position to prevent possible damage. Before setting the shipping lock, make sure
that the carrier has been returned to the home position.
Good
less than 20cm
(8 in.)
Bad Bad
Front side
Enlarged
Shipping Lock
(Position for operation)
Shipping Lock
(Position for shipment)
B
A
ADF side
Bottom view
Shipping Lock (Position for
storage, position for shipment)
Enlarged section A enlarged
ADF side
Front side