FUJITSU C150-E146-02EN - Manual (Page 41)

3-5
NOTICE
• Remove paper clips and staples. Flatten the staple holes .
• Read the following documents using the Flatbed.
- Paper with clip or staple.
- Paper with wet ink.
- Paper of uneven thickness (for example, envelopes).
- Paper with large rumples or curls.
- Paper with folds or tears.
- Tracing paper.
- Coated paper.
- Carbon paper.
- Paper smaller than A8 (portrait) size or wider than A3 size.
- Materials other than paper (for example, clothes, sheet metal, or OHP film).
- Photographic paper.
- Paper with perforations on the side.
- Non-rectangular paper.
- Very thin paper.
• Set documents on the ADF so that the curl of the leading edge does not exceed the measurements
shown below.
• To avoid skewing, do no feed docments of different widths during the same butch.
Less than
5mm
More than 30mm
Top of the paper
Less than
3mm
More than 30mm
Feed direction
Top of the paper Read surface
2
Fan the sheets before setting a stack of documents on the ADF paper chute.
Document
10mm